Induction heated the part to forming temperature more rapidly than a torch. Induction targets the precise portion of the part that requires heating every time.

Testing determined that the magnetic steel rod heated to required temperature within 1.5 seconds with an EASYHEAT LI induction heating system.

The client targeted an aggressive cycle time, achieve thanks to our process design and the efficiency of induction heating; fast heating means greater manufacturing throughput

Each of the rods were placed into the coil and heated. They achieved the targeted temperature in 30-40 seconds. The coil was designed for a 5” (127 mm) heat zone.

The client needed to improve the cycle time of their gas furnace, and by preheating it prior to insertion into the furnace, time was saved and the client didn’t have to invest in doubling the size of their furnace.

The client was using a competitor’s system, and it was heating the assembly at a slower rate. They needed to increase their production rate, which this solution was able to achieve.

The client targeted an aggressive cycle time, which Induction foster was able to achieve thanks to its process design and the efficiency of induction heating.

Fast, precise heating of the pin – 2 minutes and 36 seconds were saved on heating all of the rim’s pins when compared to using a torch.